15206-55-0 - Names and IdentifiersNameMethyl benzoylformateSynonymsMBFPI-MBFSyna 468IHT-PI MBFD
Email: info@standard-groups.com
Nama | Methyl benzoylformate |
Sinonim | MBF PI-MBF Syna 468 IHT-PI MBF Darocur MBF Photoinitiator-MBF photo sensitizer MBF Methyl benzoylformate Methyl benzoyl formate Methyl phenylglyoxylate methyl oxo(phenyl)acetate Methyl-α-oxo-phenylacetate Phenylglyoxylic acid methyl ester Glycopyrronium Bromide EP Impurity H alpha-oxo-benzeneaceticacimethylester alpha-Oxobenzeneacetic acid methyl ester Benzeneaceticacid,.alpha.-oxo-,methylester Glycopyrronium Bromide Impuritiy 3 (Methyl benzoylformate) |
CAS | 15206-55-0 |
EINECS | 239-263-3 |
InChI | InChI=1/C9H8O3/c1-12-9(11)8(10)7-5-3-2-4-6-7/h2-6H,1H3 |
Rumus Molekuler | C9H8O3 |
Massa Molar | 164.16 |
Kepadatan | 1.155 g/mL at 25 °C (lit.) |
Titik Melting | 16°C |
Titik Boling | 246-248 °C (lit.) |
Titik Flash | > 230°F |
Kelarutan air | 2g/L at 20℃ |
Penampilan | Liquid |
Gravitasi Spesifik | 1.161.155 |
warna | Clear yellow |
BRN | 1100868 |
Kondisi penyimpanan | Simpan di bawah +30°C. |
Indeks Refraksi | n20/D 1.528 |
Sifat fisik dan kimia | Density 1.155 boiling point 246-248°C refractive index 1.525-1.527 |
Deskripsi Keselamatan | 24/25 - Avoid contact with skin and eyes. |
WGK Jerman | 1 |
Kode HS | 29183000 |
Toksitas | LD50 orally in Rabbit: > 5000 mg/kg LD50 dermal Rat > 5000 mg/kg |
LogP | 1.9 at 23℃ |
preparation of benzoyl formic acid | hydrolysis of methyl benzoyl formate to give good quality benzoyl formic acid |
gas chromatographic analysis of 2, 4-dichloro-5-aminophenyl isopropyl ether | with 2.5% OV-210, 2M stainless steel packed column, with methyl benzoylformate as internal standard, at 145 ℃ column temperature, 2, 4-dichloro-5-aminophenyl isopropyl ether and 2, A mixture of 4-dichloro-5-nitrophenyl isopropyl ether was quantitatively analyzed. The coefficient of variation was 0.22% and 0.23%, the average recovery was 99.96% and 100.07%, the linear correlation coefficient was 0.9999. |
Penggunaan | methyl benzoylformate is an intermediate of the herbicide buprozin. used in organic synthesis. UV-curable coatings and inks |
metode produksi | obtained by esterification of benzoyl acid with methanol. Cyclomethanol and benzoylformic acid were added to the reaction pot, and sulfuric acid was added slowly with stirring. After heating to reflux for 12h, excess methanol was recovered. The esterification was neutralized with dilute sodium carbonate solution, the oil layer was separated, and the water layer was extracted with benzene. The extract was combined with the oil layer, dried over anhydrous sodium sulfate, and then distilled. The solvent benzene was recovered first, and then the low boiling matter was distilled off under reduced pressure. Then the 137-146 ° C. (2.4kPa) fraction was collected and taken as methyl benzoylformate. The raw material benzoylformic acid used was obtained by oxidation of styrene (see 04960), and the yield of esterification based on benzoylformic acid was more than 50%. The preparation method is to add sodium chloride and sulfuric acid in the reaction bottle, stir at room temperature, Dropwise add benzoyl nitrile, control the temperature at about 30 ℃, and keep the heat for 3 h after dropping, then methanol was added dropwise, and the temperature was raised and refluxed for 5 h. After the reaction was completed, methanol was removed under reduced pressure to obtain a finished product. |
suhu pembakaran spontan | >500°C |
Penafian: Konten di atas hanya untuk referensi dan komunikasi antara orang dalam industri, dan tidak menjamin akurasi atau kelengkapannya. Menurut hukum dan peraturan yang relevan dan peraturan situs web ini, unit atau individu yang membeli barang terkait harus memperoleh kualifikasi dan kondisi kualifikasi yang valid.
Telepon Perusahaan
+86-21-6420 0566
Jam kerja
Senin sampai Jumat
Telepon seluler:
13816217984
Email:
info@qinsun-lab.com